NEW ISSUE! Only 3.5µA power consumption in standby mode and higher sensitivity.
Very small magnetic switch for activating electronic assemblies such as altimeters, data loggers, etc.
A magnet is switched on by holding it for 1 second.
The switch is only switched off when a magnetic field is applied again for 2 seconds without interruption.
A bright red LED indicates that the unit is switched on.
The magnet can be activated through the model housing without the need for flaps, switches or holes.
Simply hold the magnet to it and off you go!
Works with a microcontroller (ATTiny13A) which guarantees safety.
Accidental switching off by a short magnetic field is impossible.
The Magswitch is connected by soldering stranded wires to 4 soldering pads with a 1.5m hole.
Fastening by double-sided adhesive tape.
Technical data:
Operating voltage: 2.7-12V (1s or 2s-Lipo possible)
Switching capacity approx. 10A
Current consumption when switched off: only 3.5µA at 7.4V
Power consumption when switched off: approx. 2.5 mAh per month
Operating time when switched off with a 150 mAh 2s-Lipo approx. 5 years!
Dimensions: 19x16.5 mm
Weight: 1,3 gramm
Delivery without magnet!
